Display and remote control systems

Connecting this module to a KNX system means adding the display and remote control device.
The only connection to the Bus line (TP cable) is sufficient to send and receive group addresses (commands and operating states) which monitor the whole system on graphics in real time.
But this module must be used in combination with at least the Basic Module DO-K1 because it includes the basic devices of a KNX Bus Line.
Panel of light insulating material easy to handle, with a wide, colour printed front surface where the devices are represented by their international electric symbols.
All the connections are carried out via safety terminals and jumpers with diameter of 4 mm for power circuits, and via terminals and jumpers of 2 mm for the Bus Line.
Module optimized to be used in combination with other modules either on table top, in horizontal/inclined position (with proper support), and/or on a wall (wall bracket).